The work bench, it's how things get done. It was a nice cool night to be out in the garage listening to a little Royals baseball.
It's this notch on the down tube that you have to do by hand. You have to miter it to both, the bottom bracket and seat tube.
The miters are a lot tighter than they look. In fact I think they are past the point of diminishing returns. Plus I'll still have to adjust it later for the stringer from tinning the seat tube to the bottom bracket.
The front triangle is all together. All the angles and lengths are good to go. Next I'm going to have to drill the vent holes, get the tubing clinically clean, and start brazing.